Aeronaut Clipper sailboat # 300200
The sailing boat Clipper is ideally suited for the beginning of the ship model building. The hull is easily assembled on the boat deck, on which the frames, the keel and the sword are simply attached and glued. The bottom of the fuselage and the side parts are made of thin plywood and are already prepared for gluing. The boat can be operated with or without a remote control with a servo for the rudder. The ballast on the sword is made of round steel, so the usual lead is not used. With this model, the young model maker gets to know the frame construction and the basic knowledge of model sailing. This kit is so well prepared that no tools are required for construction, the wooden parts are all punched out and the aluminum tubes for the mast and the trees are already cut to the correct length. The wire fittings are already bent so that they can be pushed onto the aluminum tubes. The following tools are required: pins and adhesive tape. The kit contains all wooden parts, fittings, oars and detailed instructions in German, English, French, Italian and Spanish.
Width (mm] 97Attention small parts! Not for children under 3 years.
This is a kit and had to be build completely, there is no extra hardware and electronics in the kit other then mentioned above.
Excluded for instance :
- Motor
- ESC (Electronic Speed Controller)
- Radio
- Servo's
- Battery
- Reciever
- Prop
- Paint, glue etc
Needed to complete :
Advisable to use / don't forget :