RC Factory EDGE 540T T11 Cool Blue 1000mm span EPP kit *
Here comes the EPP Edge 540 model. Those that are familiar with the previous 39” models will appreciate the new hardware and construction including rear tail control push rod assemblies with adjustability and new EPP bracing for easy assembly. While creating a new ground up airframe, the dual aileron servos have now been re-located which creates a plush/clean look. The overall flight envelope has increased greatly giving a sense of unreal control authority. Increased roll rate was achieved with the addition of outer counter balance tabs. This model was designed for the pilot wanting to learn the “next step” and also those who choose a balsa 3D model alternative.
If you prefer bigger models with fully airfoiled wing, you can´t make a mistake with these. Developed by some of the best 3D pilots for a combination of 3D capability and easy, predictable handling.
Wing span: 1000 mm
Length: 1020 mm
AUW: od 350 g
Motor: 100 - 200 W
ESC: 10 - 20 A
Servo: 4 x 9 - 12 g
Battery: 650 - 1200 3S
- Kit including landing gear, without equipment set - see photo
Recommended equipment sets (motor, servos, ESC, propeller, batterie) can be found below in accessories.
Needed to complete :
Don't forget ..... :